Toshiba P300 HDWD120UZSVA, купленный 3 года назад.Использовался как файлопомойка.
И вот что-то стал он как-то плохо себя чувствовать
smartctl 7.3 2022-02-28 r5338 [x86_64-linux-6.2.10-1-MANJARO] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Toshiba P300 (CMR) Device Model: TOSHIBA HDWD120 Serial Number: 994EPN8CS LU WWN Device Id: 5 000039 fdbc63a1c Firmware Version: MX4OACF0 User Capacity: 2 000 398 934 016 bytes [2,00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database 7.3/5319 ATA Version is: ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Tue Apr 18 20:26:27 2023 +05 SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: FAILED! Drive failure expected in less than 24 hours. SAVE ALL DATA. See vendor-specific Attribute list for failed Attributes. General SMART Values: Offline data collection status: (0x84) Offline data collection activity was suspended by an interrupting command from host. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: (14631) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 244) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 075 075 016 Pre-fail Always - 39388850 2 Throughput_Performance 0x0005 138 138 054 Pre-fail Offline - 74 3 Spin_Up_Time 0x0007 128 128 024 Pre-fail Always - 295 (Average 295) 4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 2163 5 Reallocated_Sector_Ct 0x0033 001 001 005 Pre-fail Always FAILING_NOW 2005 7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0 8 Seek_Time_Performance 0x0005 124 124 020 Pre-fail Offline - 33 9 Power_On_Hours 0x0012 099 099 000 Old_age Always - 13863 10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 2146 192 Power-Off_Retract_Count 0x0032 099 099 000 Old_age Always - 2189 193 Load_Cycle_Count 0x0012 099 099 000 Old_age Always - 2189 194 Temperature_Celsius 0x0002 150 150 000 Old_age Always - 40 (Min/Max 21/44) 196 Reallocated_Event_Count 0x0032 001 001 000 Old_age Always - 2701 197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0 SMART Error Log Version: 1 ATA Error Count: 17 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 17 occurred at disk power-on lifetime: 13857 hours (577 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 08 d8 1d 94 08 Error: UNC 8 sectors at LBA = 0x08941dd8 = 143924696 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 08 d8 1d 94 e0 08 06:16:29.641 READ DMA EXT ef 10 03 00 00 00 a0 08 06:16:29.641 SET FEATURES [Enable SATA feature] ef 10 02 00 00 00 a0 08 06:16:29.641 SET FEATURES [Enable SATA feature] 27 00 00 00 00 00 e0 08 06:16:29.641 READ NATIVE MAX ADDRESS EXT [OBS-ACS-3] ec 00 00 00 00 00 a0 08 06:16:29.638 IDENTIFY DEVICE Error 16 occurred at disk power-on lifetime: 13857 hours (577 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 f0 e8 1e 94 08 Error: UNC 240 sectors at LBA = 0x08941ee8 = 143924968 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 00 d8 1e 94 e0 08 06:16:19.001 READ DMA EXT 25 00 00 b8 64 81 e0 08 06:16:18.962 READ DMA EXT 25 00 00 b8 62 81 e0 08 06:16:18.960 READ DMA EXT 25 00 00 b8 61 81 e0 08 06:16:18.946 READ DMA EXT ef 10 03 00 00 00 a0 08 06:16:18.946 SET FEATURES [Enable SATA feature] Error 15 occurred at disk power-on lifetime: 13857 hours (577 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 08 78 60 5c 03 Error: UNC 8 sectors at LBA = 0x035c6078 = 56385656 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 08 78 60 5c e0 08 06:14:07.384 READ DMA EXT 25 00 00 78 d8 81 e0 08 06:14:07.370 READ DMA EXT ef 10 03 00 00 00 a0 08 06:14:07.369 SET FEATURES [Enable SATA feature] ef 10 02 00 00 00 a0 08 06:14:07.369 SET FEATURES [Enable SATA feature] 27 00 00 00 00 00 e0 08 06:14:07.369 READ NATIVE MAX ADDRESS EXT [OBS-ACS-3] Error 14 occurred at disk power-on lifetime: 13857 hours (577 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 08 78 60 5c 03 Error: UNC 8 sectors at LBA = 0x035c6078 = 56385656 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 08 78 60 5c e0 08 06:14:03.289 READ DMA EXT 25 00 08 70 60 5c e0 08 06:14:00.161 READ DMA EXT 25 00 00 78 d6 81 e0 08 06:14:00.154 READ DMA EXT 25 00 00 78 d7 81 e0 08 06:14:00.132 READ DMA EXT ef 10 03 00 00 00 a0 08 06:14:00.131 SET FEATURES [Enable SATA feature] Error 13 occurred at disk power-on lifetime: 13857 hours (577 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 08 68 60 5c 03 Error: UNC 8 sectors at LBA = 0x035c6068 = 56385640 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 25 00 08 68 60 5c e0 08 06:13:56.235 READ DMA EXT 25 00 00 78 d5 81 e0 08 06:13:56.234 READ DMA EXT 25 00 00 78 d4 81 e0 08 06:13:56.214 READ DMA EXT ef 10 03 00 00 00 a0 08 06:13:56.213 SET FEATURES [Enable SATA feature] ef 10 02 00 00 00 a0 08 06:13:56.213 SET FEATURES [Enable SATA feature] SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 12078 - # 2 Short offline Completed without error 00% 12064 - # 3 Short offline Completed without error 00% 12049 - # 4 Short offline Completed without error 00% 12035 - # 5 Short offline Completed without error 00% 12023 - # 6 Short offline Completed without error 00% 12012 - # 7 Short offline Completed without error 00% 11986 - # 8 Short offline Completed without error 00% 11972 - # 9 Short offline Completed without error 00% 11957 - #10 Short offline Completed without error 00% 11942 - #11 Short offline Completed without error 00% 11919 - #12 Short offline Completed without error 00% 11898 - #13 Short offline Completed without error 00% 11883 - #14 Short offline Completed without error 00% 11868 - #15 Short offline Completed without error 00% 11853 - #16 Short offline Completed without error 00% 11838 - #17 Extended offline Interrupted (host reset) 10% 11830 - #18 Short offline Completed without error 00% 11815 - #19 Short offline Completed without error 00% 11800 - #20 Short offline Completed without error 00% 11785 - #21 Short offline Completed without error 00% 11750 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.
Если ошибаюсь поправьте.
Если таки он труп - хотел бы услышать что можно взять понадежнее для тех же целей(объем можно больше)
